Third project it quite tricky I guess, because this time we have to do something exactatelly the same, but is also a good co-oporation experience. So we started at two template.

lol, this face.

We want to make sure the size would be perfect fit, though we chose to do a large piece at begining, but then we know we wrong.

Hammering

The corner is the most tricky part, have to hammer it and cut it and hammer again to keep it in radius edge without stack on each other.

finish all the straight edges.

The wood template we used to refine the radius is totally broken some how, and we cant get the same template again which mains the edges is not compatible at all.

Then we end up doing a small one which is much easier after all, just get a same shape template, and hammer on it, I made four template this time for us, them we could tight to pieces together to make sure the corner part would not fall off or getting drag by unsupported side, and this time become much quick as well.

Hammering

Finish lol~

complete fit on surface, but only issue right now is I haven't see my teammates for few weeks, so we can't compare our final stuff to see how perfect it would be fit in which is sad, but I believe we will do this asap.